EINHELL BT-SM 1800 Originalbetriebsanleitung Seite 43

Move the machine head (4) to
•
its upper position.
Use the handle (1) to push
•
back the machine head (4)
and fix it in this position if re-
quired (dependent on the cut-
ting width).
Place the piece of wood to be
•
cut at the stop rail (11) and on
the turntable (17).
Lock the material with the
•
clamping device (8) on the
fixed saw table (18) to prevent
the material from moving du-
ring the cutting operation.
Push down the release lever
•
(3) to release the machine
head (4).
Press the ON/OFF switch (2)
•
to start the motor.
With the drag guide (23) fixed
•
in place: Use the handle (1)
to move the machine head (4)
steadily and with light pres-
sure downwards until the saw
blade (7) has completely cut
through the workpiece.
With the drag guide (23) not
•
fixed in place: Pull the machi-
ne head (4) all the way to the
front and then use the handle
to move it downwards steadily
and with light pressure. Now
push the machine head (4)
slowly and steadily to the very
back until the saw blade (7)
Anl_BT_SM_1800_SPK7.indb 43 Anl_BT_SM_1800_SPK7.indb 43
GB
has completely cut through
the workpiece.
When the cutting operation is
•
completed, move the machi-
ne head (4) back to its upper
(home) position and release
the ON/OFF button (2).
Important. The integral resetting
springs will automatically lift the
machine head. Do not simply let
go of the handle (1) after cutting,
but allow the machine head (4) to
rise slowly, applying slight coun-
ter pressure as it does so.
6.2 Cross cut 90° and turntab-
le 0° - 45° (Fig. 1-3, 12)
The crosscut saw can be used to
make crosscuts of 0°- 45° to the
left and 0° - 45° to the right in re-
lation to the stop rail.
Release the turntable (17) by
•
slackening the locking screw
(14).
Turn the turntable (17) and
•
scale pointer (15) to the desi-
red angular setting on the dial
(16) and lock into place with
the locking screw (14). The
saw has locking positions at
angles of - 45°, -31.6°, -22.5°,
-15°, 0°, 15°, 22.5°, 31.6° and
45°, at which the turntable
(17) audibly clicks into positi-
on.
Retighten the locking screw
•
- 43 -
26.07.2018 07:46:52 26.07.2018 07:46:52