bort medical select Stabilo Gebrauchsanweisung Seite 8

EN
– whilst wearing the support, please neither use any creams nor ointments on or
around it as they can destroy the material
Fitting instructions
Open the support, place it around the waist and attach both closing sides using
Velcro evenly one above the other with a slight pull of the hand straps. Ensure
that the support is placed centrally and the lower edge of the support ends in the
inguinal region (forward bend). The support should sit tightly, but not constrain.
Pay attention to comfortable fitting. In order to additionally relieve the lumbar spine,
tighten the side restraints evenly and simultaneously. Observe simultaneous pull
on both side restraints in order to avoid undesired rotation on the spine. The pad
is attached to the support with Velcro and can be freely positioned. Ensure that the
wide side of the pad points towards the head.
Removal
To remove the brace, open the restraints and the front closure and remove the brace.
Material composition
Elastodiene/latex (LA), polyamide (PA)
The sewn in textile label provides the precise material composition.
The product contains latex and can trigger allergic reactions.
Cleaning information
Delicate wash Do not clean chemically Do not bleach
Do not dry in a tumble dryer Do not iron
Do not use fabric conditioner. Stretch back into shape and dry in the fresh air. Close
the Velcro fastening to avoid damage to other laundry items.
Guarantee
The legal regulations of the country in which you acquired the product apply to the
purchased product. Please contact your specialist retailer if you suspect a warranty
08