Beper MD.500 Handbuch Seite 5

Pasta machine Use instructions
This pasta machine is for household use only and it is made accor-
ding to high quality standards.
It will offer you reliability and safety over time, allowing you to make
the best fresh pasta with natural ingredients chosen by you, in the
comfort of your own home.
This handbook is an integrating part of the machine. Please read
carefully all the rules of safety, instructions and warranty conditions
before using the machine. Keep this handbook carefully and keep it
at hand to be able to refer to it for any need. For any doubts or unfo-
reseen use, inquire with your dealer before installation.
Attention! Any use of the machine not provided for herein shall
be considered incorrect or improper. The machine is intended
only and exclusively for mixing, rolling or cutting pasta and
may not be used for other purposes.
The manufacturer disclaims any liability in the event of: im-
proper use; incorrect installation; alterations or operations
not authorized by the manufacturer, use of non-original spa-
res or not specific to the model.
Description of the machine Fig.A
1. Machine body
2. Handle
3. Clamp
4. Cutter roller attachment slot
5. Clamp housing slot
6. Stretching roller attachment slot
7. Adjustment knob
8. Stretching rollers
9. Cutter rollers
10. Knob lever
11. Clamp screw
Use of the machine
Before each use: follow the instructions given in the "Cleaning and maintenance" paragraph.
Set the pasta machine near the edge of a firm surface, suitable to bear its weight, insert the clamp in the clamp
housing slot, tighten the clamp screw until the machine is firmly clamped to the working surface.
Keeping the lever pressed, turn the adjustment knob to position 9 (max roller opening), insert the handle in the
attachment slot of the machine, lay part of the previously prepared dough on the stretching rollers and turn the
handle clockwise (making the stretching rollers turn). This will allow you to obtain a first shaping of the dough
sheet. Fold it in two and pass it through the rollers again to make it even.
To reduce the thickness, turn the adjustment knob clockwise to reduce the distance between the stretching
rollers.
Pass the dough through again repeating the operation until obtaining the desired thickness.
To cut the sheet with the cutter rollers, after choosing the required cutting size, remove the handle from the at-
tachment slot and insert it in one of the attachment slots.
Rest one end of the sheet on the cutter rollers and turn the handle
clockwise.
The dough must be kept at room temperature.
5
EN