Displayed Icons (Symbols) And Messages In Rcd Function - PeakTech 2755 Bedienungsanleitung

5.1.3. Displayed icons (symbols) and messages in RCD function

If the wiring condition is other than normal, the Tester is limited on its measurements that can be
performed.
Notes:
1) Will not detect two hot wires in a circuit.
2) Will not detect a combination of defects.
3) Will not detect reversal of grounded and grounding conductors.
Half Trip
UL OVER
Downloaded from www.Manualslib.com
Indicates the battery status
100%
80%
50%
30%
Low Battery
Indicates high temperature and therefore cannot make any
measurements
Appears during the auto test when rcd has operated on the x ½ test
Half
Appears during the manual test when rcd has operated on the x ½ test
Appears when UF voltage exceeds the previously set UL voltage. (UL
voltage can be set to 25V or 50V) The user must check the impedance
between L-PE
manuals search engine
Indicates the correct input terminal connectivity .
The user should connect the test leads to the
appropriate terminals.
Indicates L connection is connected on the N
input terminal and vice-versa
Indicates no connection on the PE input terminal
-67-