Troubleshooting Guide - Braun TexStyle 7 Pro Handbuch

DLB253489_5712710601_SI7_UI_INT.indb 11
Downloaded from www.Manualslib.com

Troubleshooting Guide

PROBLEM POSSIBLE CAUSES
The water tank lid is not properly
closed.
Chemicals have been put into the
Water droplets drip on the
water tank
fabric during ironing.
The steam trigger is overused .
The water tank is empty.
The valve has collected too much
The iron produces little or no limescale.
steam.
Temperature is not high enough and
anti-drip function automatically gets
activated to avoid water drops.
Flakes and white impurities The iron has limescale formations
come out during ironing. inside the steam chamber.
The spray function or the
steam shot do not work The water tank is empty.
properly.
Subject to change without notice.
Please do not dispose of the product in the household waste at the end of its useful
life. Disposal can take place at a Braun Service Centre or at appropriate collection
points provided in your country.
manuals search engine
SOLUTION
Press the water tank lid and check
if it is closed .
Never put chemicals or perfumes
into the water tank. Empty the
water tank, rinse it 2-3 times.
Wait a few seconds between each
use. Check that the temperature
selector is at least on ••.
Refill the water tank.
Clean the valve.
Check that the temperature
selector is at least on••.
Run the descaling procedure
(clean the steam chamber and the
valve).
Refill the water tank.
21.12.16 09:51
11