Residual Heat Indicator; Setting The Hob; Switching The Hob On And Off; Setting A Hotplate - NEFF T1.D20-Serie Gebrauchsanleitung

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the
#
indicator above the main switch lights up. The hob is ready for
use.
To switch off: touch the
#
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
Notes
The hob switches off automatically if all hotplates have been
■
switched off for more than 15 seconds.
The settings remain stored for 4 seconds after the hob has
■
been switched off. If you switch it on again during this time,
the hob will operate using the previously stored settings.

Setting a hotplate

Use the + and - symbols to set the desired heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.

Table of cooking times

The following table provides some examples.
Cooking times and heat settings may vary depending on the
type of food, its weight and quality. Deviations are therefore
possible.
Melting
Chocolate, cooking chocolate, butter, honey
Gelatine
Heating and keeping warm
Stew (e.g. lentil stew)
Milk**
Heating sausages in water**
Defrosting and heating
Frozen spinach
Frozen goulash
* Continue cooking without a lid
** Without lid
symbol. A signal sounds. The
symbol until the display above the
If • appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to œ . The display remains lit until the hotplate has
cooled sufficiently.
Set the heat setting
The hob must be switched on.
Touch the ( ) symbol for the required hotplate.
1.
the display.
Touch + or - within the next 5 seconds. The basic setting
2.
appears.
+ symbol: heat setting 9
- symbol: heat setting 4

Changing the heat setting: touch the + or - symbol until the
3.
desired heat setting appears.
To switch off the hotplate:
Use the ( ) symbol to select the hotplate. Touch the + or -
symbol until ‹ appears. After about 5 seconds, the residual
heat indicator appears.
Note: Hotplate temperature is regulated by the heat switching
on and off. The heat may also switch on and off at the highest
setting.
When heating thick liquids, stir regularly.
For bringing liquids to the boil, use heat setting 9.
Ongoing cooking
setting
1-2
1-2
1-2
1.-2.
3-4
2.-3.
2.-3.
‹ lights up in

Ongoing cooking
time in minutes
-
-
-
-
-
20-30 mins
10-15 mins
23