Operation; Standard Equipment; Care And Maintenance - METRICA BRAVO LASER 360 + 2V Bedienungsanleitung

OpErAtiON

- Open the battery cover,insert 3AA batteries and close the cover.
- Unlock button "1" to turn the instrument on and release the
pendulum
- The horizontal plane is projected
- Press the button (2) of laser line once: a vertical line is
projected
- Press the button (2) of laser line again: the second vertical line
is projected
- Press the button (2) of laser line again: the horizontal plane
switches off but the two vertical lines at 90 ° to each other
remain visible
- Press the button (2) of laser line again: the unit returns to the
horizontal plane only.
By continuing to press this button, the cycle of operations de-
scribed above will be repeated.
- Press the button (3) "Indoor / Outdoor switch": the button will
be back- lightened indicating that the function is active for
outdoor use. It is possible to use the detector (optional) to find
the position of the laser line. Note: entering the outdoor mode
the brightness of the laser is reduced.
- If the battery charge drops below 3V, the unit emits a warning
signal: replace the batteries as soon as possible.
NOtES
The laser unit should be placed on a flat surface like a table, floor
etc. The self-leveling range is ± 3°. If the unit moves outside the
self-leveling range, the line laser begins to blink and the laser
unit emits a sound signal.
Lock the pendulum and put the laser unit in the soft case when
not in use.

StANDArD EqUipMENt

Laser units, magnetic bracket, target, batteries, soft carrying
case, and adapter 5/8.
Optional accessories: detector with bracket clamp, glasses,
extendable tripod

CArE AND MAiNtENANCE

This device is a product of high quality and production and it
must be treated with care.
It should also be transported or handled with care to avoid falls,
shock or vibration.
Here are some suggestions:
• Keep your device, all its parts and accessories out of the
reach of children.
• Do not store in warm areas, high temperatures can reduce
the life of the electronic device, damage batteries, and warp
or melt plastic parts.
• Do not store in cold areas because when the unit warms up to
its normal operating temperature, moisture can form inside,
threatening to damage circuits.