Maintenance; Safety Instructions - Kermi KNN Gebrauchs- Und Montageanleitung

EN – Instructions for use
Installation and repair may be performed only
by a qualified tradesman.
Permissible use
The floor / wall brackets may be used only for
installation of convectors with the following
characteristics:
Fin housing width 50 mm
Header pipe width 11 mm
Fin spacing 17 mm
Any other use is contrary to its intended pur-
pose and therefore not permissible!

Maintenance

Special maintenance of the floor / wall bracket
is not required.
Complaint
Please contact your specialist in case of dam-
age!

Safety instructions

Thoroughly read through the assembly in-
structions before starting installation.
Heed all instructions regarding installation
site, technical data, application limits, wall
and floor conditions and wall spacing.
After installation pass the instructions on
to the end used.
Store and transport the mounting hard-
ware only in the protective packaging.
Disposal
Packaging and any parts that are not need-
ed should be recycled or disposed of prop-
erly. Observe local regulations.
WARNING
Risk of injury!
Take the weight of the convector into ac-
count (see manufacturer's data).
At 25 kg and above, work with lifting
equipment or several persons.
EN – Installation instructions
The convector may be installed only by a quali-
fied tradesman.
Number of floor / wall brackets
Depending on the type and length, use the
specified number of floor / wall brackets
when installing each convector.
Convector with radiation shield
Install convectors with a shield with the
shield facing the outside wall.
Mounting the bracket feet to the shield is not
permitted.