Troubleshooting - Ryobi RHT2660R Übersetzung Der Originalanleitung

TROUBLESHOOTING

Problem
Engine will not start.
Engine starts but will not
ac cel er ate.
Engine starts but will only
run at high speed at half
choke.
Engine does not reach full
speed and emits ex ces sive
smoke.
Engine starts, runs, and
accelerates but will not idle.
Downloaded from www.Manualslib.com
Possible cause
No spark
No fuel
Engine is fl ooded
Starter rope is hard to pull.
Engine requires approximately
three minutes to warm up.
Carburettor requires adjustment.
Lubricant and fuel mixture is
incorrect.
Air fi lter is dirty.
Spark arrestor screen is dirty.
Idle speed screw on carburettor
requires adjustment
manuals search engine
Solution
Check for spark. Remove the spark plug.
Reattach the spark plug cap and lay spark plug on
metal cylinder. Pull the starter rope and watch for
spark at spark plug tip. If there is no spark, repeat
test with a new spark plug.
Push primer bulb until the bulb is full of fuel. If
bulb does not fi ll, the primary fuel delivery sys tem
is blocked. Con tact a servicing dealer. If prim er
bulb fi lls, engine may be fl ooded, proceed to next
item.
Pull starter three times with the choke lever at
position. If engine does not start, move choke
lever to position and repeat normal starting
procedure. If engine still fails to start, repeat
procedure with a new spark plug.
Contact a servicing dealer.
Allow engine to completely warm up. If engine
does not accelerate after three minutes, contact a
ser vic ing dealer.
Contact a ser vic ing dealer.
Use fresh fuel and the correct 2-stroke lubricant
mix.
Clean the air fi lter. Refer to Clean ing the Air Filter
section in this manual.
Contact a servicing dealer.
Contact a servicing dealer.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
English | 7