Connections To Receiver; Equipment For Combustion Engine - Carson Reflex Wheel ultimate touch 2.0 Betriebsanleitung

CONNECTIONS TO RECEIVER

Battery eliminator is installed in the receiver circuitry. The receiver
gets supplied with current through the drive battery that runs the
engine. NiMH battery from 6 V to 8.4 V can be used for the receiver.
Electronic speed controller
(not included)

EQUIPMENT FOR COMBUSTION ENGINE

Receiver batteries and two servos are not included in the kit.
To receiver battery
Receiver
Regard the
form of the
connector!
ATTENTION
When connecting the servo to the receiver
always regard the form of the connector! The
black wire is facing outward!
GB // 44
Downloaded from www.Manualslib.com
Channels
Receiver switch
manuals search engine
Batteries of higher voltage may damage the receiver and servos. Use
only a speed controller which has the exclusive connector for the
BEC system.
Connector motor
Connector battery
Power switch On-/Off
Steering servo Channel 1
(not included)
ATTENTION
Make sure that male and female
connectors have the correct polarity!
Receiver: Do not connect a separate power
supply to the receiver!
Servo Channel 3 *
Servo Channel 3 *
Throttle servo Channel 2 *
* not
included Steering servo Channel 1 *