This will take you to the submenu for setting the submenu items (see table, select with UP and DOWN, confirm with ENTER, change value or
status with UP and DOWN, confirm with ENTER).
Settings
Wireless
= W-DMX settings
Settings
Power Mode
=
Battery mode
Display
= Rotate display
Reverse
Display
= Display lighting
DMX Fail
= Operating status with DMX signal fault
Power Fail
= Operating status in the event of a
power failure
Dimmer
= Dimmer curve
Curve
DimResp.
= Dimmer response
LED Calibra-
= Colour calibration
tion
Auto Lock
= Automatic locking of the controls
IR Remote
= Activate or deactivate control by IR
remote control
Charge
= Activate or deactivate battery charging
Switch
during operation (LEDs on)
Factory Reset
= Reset to factory settings
Operation with the charging
device or battery permitted
only in dry interior areas!
W-DMX On/Off
On = W-DMX enabled
Off = W-DMX disabled
Reset
Press ENTER = Reset pairing with a transmitter and
ready for new pairing
Standard
Function disabled
Eco
Approx. twice the battery life at 50% brightness
On
Display is rotated by 180° (e.g. for overhead installation)
Off
No display rotation
On
Permanently on
Off
Deactivation after approximately 1 minute of inactivity
Hold
Last command is retained
Blackout
Activates blackout
White
All the LEDs have 100% output
Off
No change to current status
On
All the LEDs have 100% output
Linear
Light intensity increases linearly with DMX value
Exponential
Light intensity can be finely adjusted at lower DMX
values and broadly adjusted at higher DMX values
Logarithmic
Light intensity can be broadly adjusted at lower DMX
values and finely adjusted at higher DMX values
S-Curve
Light intensity can be finely adjusted at lower and
higher DMX values and broadly adjusted at medium
DMX values
LED
Lamp responds abruptly to changes in DMX value
Halogen
Spotlight behaves like a halogen spotlight with soft
brightness changes
Red, Green, Blue,
Individual colour calibration. Cross-mode brightness
White, Amber, UV
setting of the 6 LED groups RGBWA+UV with values
from 000 to 255
On
Automatic locking of the controls after approximately
1 minute of inactivity. Display shows: "LOCKED"
To unlock: press and hold UP and DOWN simultaneously
for approx. 5 seconds
Off
Automatic locking of the controls is disabled
On
IR remote control activated
Off
IR remote control deactivated
On
When the spotlight is in operation, the battery can be
charged using the optionally available charging device
(max. 1 spotlight per charging device)
Off
When the spotlight is in operation, the battery cannot
be charged using the optionally available charging
device (charging only possible with LED blackout)
Reset Now?
Resetting to factory settings:
Perform reset with ENTER, cancel with MENU
11