Fitting An Sds Tool/Keyless Chuck; Removing An Sds Tool; Operation; Select Operating Mode - Parkside PABH 20-Li B2 Originalbetriebsanleitung

Fitting an SDS tool/Keyless chuck

WARNING!
Do not use the quick-action drill
►
chuck in hammer drilling or chiselling

operation!

♦ Grease the tool holder
inserting the tool.
♦ Insert the tool rotatingly into the tool holder
until it clicks into place.
♦ Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.

Removing an SDS tool

♦ Pull the locking sleeve
remove the tool.
│ GB │ CY
■ 8
slightly before
backwards and
Operation

Select operating mode

■ Use the "Drill/hammer drill" switch
the operating mode of the power tool.
NOTE
► Change the mode only when power tool is
switched off. Otherwise, the tool could be
damaged.
♦ To change the operating mode, turn the "Drill/
hammer drill" switch
Hammer drilling = Hammer ON
Drilling/screwing = Hammer OFF

Setting the rotation direction

NOTE
► Operate the rotation direction switch
when the appliance is at a standstill.
■ You can use the rotation direction switch
change the direction of rotation of the power
tool. This is not possible, however, while the on/
off switch is pressed in.
Clockwise
♦ For drilling and screwing in screws, turn the
rotation direction switch
as the stop.
♦ Anti-clockwise
♦ For undoing and removing screws and nuts, turn
the rotation direction switch
far as the stop.
to select
to the desired position.
only
to
to the left as far
to the right as
PABH 20-Li B2