Cleaning; Returning The Device; Disposal; Accessories And Spare Parts - Stahl 8150/0 Betriebsanleitung

Cleaning

EN
9 Cleaning
EN
Check the device for damage before and after cleaning it. Take damaged devices

EN
out of operation immediately.
To avoid electrostatic charging, the devices located in hazardous areas may only
EN

be cleaned using a damp cloth.
EN
When cleaning with a damp cloth, use water or mild, non-abrasive, non-scratching

EN
cleaning agents.
EN Do not use aggressive detergents or solvents.

Never clean the device with a strong water jet, e.g. using a high-pressure washer!

EN
EN
10

Returning the device

EN
Only return or package the devices after consulting R. STAHL! Contact the responsible

EN
representative from R. STAHL.
EN
EN
R. STAHL's customer service is available to handle returns if repair or service is required.
EN
Contact customer service personally.

EN
EN
or
EN
Go to the www.r-stahl.com website.

EN
Under "Support" > "RMA form", select "Request RMA slip".

EN
Fill out the form and send it.

Confirmation will be sent. R. STAHL's customer service will contact you.
EN
You will receive an RMA slip after speaking with customer service.
EN
Send the device along with the RMA slip in the packaging to R. STAHL Schaltgeräte

EN
GmbH (refer to Section 1.1 for the address).
EN
EN
11

Disposal

EN
Observe national and local regulations and statutory regulations regarding disposal.

Separate materials when sending them for recycling.

Ensure environmentally friendly disposal of all components according to the statutory

regulations.
12

Accessories and Spare parts

NOTICE! Malfunction or damage to the device due to the use of non-original
components.
Non-compliance can result in material damage.
Use only original accessories and spare parts from R. STAHL Schaltgeräte GmbH

(see data sheet).
10
Empty Enclosure
Series 8150/0
168471 / 815060300010
2018-03-06·BA00·III·en·05