Functions Of On/Off Button; With Led; Touch Screen; Initial Commissioning - Bosch DCU 100 Originalbetriebsanleitung

de | 18 | DCU 100 | Initial commissioning
3.5.2

Functions of On/Off button

DCU 100 Power supply
unit
Off Not connected Off
Off Connected
Booting Connected /
not connected
On and LCD Connected
on
On and LCD Not connected Green light Battery charge
off
On and LCD Not connected Flashing
off
On, LCD off, in Connected /
energy saving not connected
mode
On, LCD off, in Connected /
energy saving not connected
mode
3.6

Touch screen

The touch screen can be operated by hand or using a
pen. To implement an action, touch the appropriate
point on the touch screen with a finger or pen.
i
Touch screen calibration is described in
Section 5.8.2.
|
1 689 989 283 2020-02-24

with LED

State
LED
–
Green light Battery charge
≥ 80 %
Yellow light Battery charge
< 80 %
Flashing Battery charge
red < 10 %
Off –
Off Battery being
charged
≥ 10 %
Battery charge
red < 10 %
Flashing Battery charge
green ≥ 10 %
Flashing Battery charge
red < 10 %
4.

Initial commissioning

¶
Remove the DCU 100, the storage battery and the
power supply unit with power supply cable from
the case.
4.1

Fitting the storage battery

¶
Insert the battery in the battery compartment and
secure by means of the two screws on the battery
(see fig. 3, item 3).
i
It is advisable to charge the storage battery for at
least three hours before running the DCU 100 off
the battery.
4.2

Port

Prior to the initial commissioning, make sure the mains
voltage matches the voltage specified on the power
supply unit (use the power supply cable provided).
4.3

Configuration of the operating system

1. Supply the DCU 100 with voltage by way of the
power supply unit.
2. Switch on DCU 100.
3. After switching on for the first time, select the
Windows operating system language via the lan-
guage selection menu and follow the on-screen
instructions.
i
The on-screen keyboard can be opened in the
"Ease of Access Center" window (Icon
 The Windows 10 start screen appears after
some time.
"
The adjustment of the Windows operating system is
complete.
4.4 ESI[tronic] 2.0 software installation
1. Start ESI[tronic] 2.0.
2. License ESI[tronic] 2.0.
i
ESI[tronic] 2.0 licensing is performed by way of
a file or online. Information on licensing can be
found in the ESI[tronic] 2.0 Online Help.
4.5

Software installation

i
During a software installation always supply the
DCU 100 with voltage via the power supply unit.
i
See the installation instructions provided with the
respective software for additional information con-
cerning installation and update of the software.
).
Robert Bosch GmbH