AEG IDE84242IB Montage- Und Gebrauchsanweisung Seite 61

USING THE EXTRACTOR FAN
Power-on
Press (touch) ON/OFF hob/ extractor
The indicator light will turn on to indicate that the hob/extractor
is ready for use
Press again to turn off
Note: This function has priority over the others.
Switching on the extractor fan:
Touch (press) the selector
Extraction speed (power):
touch (press) the selector
speed (power) (0-10);
touch (press) the selector
speed (power) (10-0);
12. Timer
Activation/Regulation of Timer function for the
extractor fan
• Select the extractor fan
• Press (5) to access the Timer function (from any
speed)
• Regulate the duration of the Timer:
press the selector
shut-down time
press the selector
shut-down time
the display (10) will show the countdown,
Note: on the side of the display of the extractor fan, with the
Timer in use, the following symbol will appear
When the timer has finished the countdown, there is an
acoustic signal (for 2 minutes, or it will stop when one of the
buttons on the hob is pressed) , while the display (10) will
flash, with the symbol "
to activate the extractor fan
, to increase the extraction
, to decrease the extraction
, to increase the automatic
, to decrease the automatic
(9)
".
To switch off the Timer:
• select the cooking zone
• set the value of the timer to " " , by means of
Note: the function remains active if no other key is pressed
in the meantime.
Grease Filter saturation indicator
The hood indicates when it is necessary to perform
maintenance on the filters:
LED (11) turns on
Resetting activated carbon odour filter saturation
After performing maintenance on the filters, hold down the key
; the LED
again.
Automatic mode (Hob
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the cooking level used in the cooking
zone.
Once the hob is turned off, the hood adapts its aspiration
speed, gradually decreasing it, so as to eliminate residual
vapours and odours
To activate this function:
Briefly press , LED
that the hood is working in this mode.
The suction surface is designed to be used in
combination with a Window sensor KIT (not provided by
the manufacturer)
When installing the Windows sensor KIT (only in the case of
use of the surface in SUCTION mode), the suction will stop
operating every time when the KIT which with the surface is
equipped detects that the window is closed in the room where
it is installed.
It is recommended the purchase of the FDS KIT - 100
Elektrotechnik Schabus, available at authorised Elektrotechnik
Schabus centres or directly on the Internet site
www.elektrotechnik-schabus.de.
- The electrical connection of the suction surface KIT
must be carried out by qualified and specialised technical
personnel.
- The manufacturer of the suction surface declines all
responsibility for any inconvenience, damage or fire
caused by defects and/or problems of malfunctioning
and/or incorrect installation of the KIT.
61
will turn off, and the countdown will start
Hood)
2
(11) will light up to indicate