Bosch KGN Serie Gebrauchsanleitung Seite 42

en Home Connect
Connect the mobile device with the
6.
WLAN network "HomeConnect".
Password: "HomeConnect"
It can take up to 60 seconds to
establish the connection.
After successfully connecting, open
7.
the Home Connect app on the
mobile device.
The app will search for the
refrigerator.
As soon as the refrigerator has been
8.
found, enter the network name
("SSID") and the password ("Key") of
your own home network (WLAN) into
the corresponding fields.
Confirm with the button Transmit to
9.
domestic appliances.
If the connection is successful,
–
the freezer compartment
temperature display shows On
and the energy saving mode
display lights up.
You can now connect the
refrigerator with the app.
If the freezer compartment
–
temperature display shows OF,
no connection could be
established.
Check whether the refrigerator is
located within the range of the
home network (WLAN).
Repeat the process.
Connecting the refrigerator with the
app
Press the alarm off button.
1.
The refrigerator compartment
temperature display shows Cn.
Press button + refrigerator
2.
compartment until the refrigerator
compartment temperature display
shows PA and the freezer
compartment temperature display
shows OF.
Press the button + freezer
3.
compartment to connect the
appliance with the app.
The freezer compartment
temperature display shows an
42
animation and the energy saving
mode display lights up.
Wait until the refrigerator is displayed
4.
in the Home Connect app on the
mobile device.
If the refrigerator is not automatically
displayed, first select Search for
domestic appliances and then
Connect domestic appliance in the
Home Connect app.
Follow the instructions in the app
5.
until the process is complete.
Refrigerator compartment
temperature display shows Pa and
freezer compartment temperature
display shows On.
The refrigerator is successfully
connected with the app.
If the connection fails, check whether
the mobile device is connected to
the home network (WLAN).
Then try to establish the connection
again.
If Er appears in the freezer
compartment temperature display,
reset the Home Connectsettings.
When resetting, all the Home
Note:
Connect settings are reset.
Verify signal strength
You should verify the signal strength if
no connection can be established.
Press the alarm off button.
1.
The refrigerator compartment
temperature display shows Cn.
Press button + refrigerator
2.
compartment until the refrigerator
compartment temperature display
shows SI. In the freezer
compartment temperature display, a
value appears between 0 (no signal)
and 3 (full signal).
The signal strength should be at
least 2. If the signal strength is too
weak, the connection may be
interrupted.
Place the router and refrigerator
–
closer together.