Charging The Power Bank - Silvercrest SPS 5000 A1 Bedienungsanleitung

Charging the power bank

Before using the power bank, the integrated battery must be fully
charged.
CAUTION
► The power bank must never be charged and used for charging
an external device at the same time.
► Due to the high battery capacity and bearing in mind the charging
time, we recommend charging the power bank using the mains
adaptor.
► Use only a mains adapter with an output voltage of 5 V and
an output current of at least 1 A or a USB 3.0 port on your
computer to charge the power bank.
You can recognise the USB 3.0 port due to the blue marking.
► When charging via a USB port, ensure that at least one further
USB port remains free. This also applies when using USB 3.0
ports.
► Not all USB 2.0 ports deliver sufficient power to charge the
power bank. If this is the case, use an external power supply or
a USB 3.0 port.
♦ Connect the USB plug on the charging cable
PC or a USB power supply (not supplied).
♦ Connect the microUSB plug on the charging cable
microUSB charging port
of the charge level is shown during charging by means of the
charge level LEDs
│
■ 8
Downloaded from www.Manualslib.com
GB │ IE │ NI
manuals search engine
on the Power Bank. A rough estimate
.
to a switched-on
to the
SPS 5000 A1