Clear Cmos Jumper (Clrcmos1) - ASROCK FM2A58M-VG3+ R2.0 Handbuch

1.3 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose
pin1 and pin2 are "Short" when jumper cap
is placed on these 2 pins.
Jumper
Clear CMOS Jumper
(CLRCMOS1)
(see p.2, No. 15)
Note: CLRCMOS1 allows you to clear the data in CMOS. To clear and reset the
system parameters to default setup, please turn off the computer and unplug
the power cord from the power supply. After waiting for 15 seconds, use a
jumper cap to short pin2 and pin3 on CLRCMOS1 for 5 seconds. However,
please do not clear the CMOS right after you update the BIOS. If you need
to МlОКr tСО CMOS аСОn вou Уust inТsС updКtТnР tСО BIOS, вou must Лoot
up tСО sвstОm irst, Кnd tСОn sСut Тt doаn ЛОПorО вou do tСО МlОКr-CMOS КМ-
tТon. PlОКsО ЛО notОd tСКt tСО pКssаord, dКtО, tТmО, usОr dОПКult proilО, 1394
GUID and MAC address will be cleared only if the CMOS battery is removed.
10
Setting
Default
If you clear the CMOS, the case open may be detected. Please adjust the
BIOS option "Clear Status" to clear the record of previous chassis intrusion
status.
Description
Clear CMOS