Original Accessories / Tools; Start-Up; Attaching / Changing The Tool / Collet; Grinding Bits - Parkside PFBS 160 A1 Bedienungs- Und Sicherheitshinweise

General power tool safety warnings / Start-up
off! Avoid contact with rapidly rotating drill /
grinder components.
piece. Use clamps or a vice to grip the workpiece
firmly. This is much safer than holding it in your
hand.
support yourself by placing your hands near or
in front of the device or the workpiece surface.
A slip can result in injury.
DANGER oF FIRE FRoM FLYING SPARKS!
Abrading metal creates flying sparks. For this
reason, always make sure that nobody is placed
in any danger and that there are no inflammable
materials near the working area.
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
Its use as a saw or the use of saw blades with
this device is prohibited.
Do not soak the materials or the surface you are
about to work on with liquids containing solvents.
Avoid abrading paints containing lead or other
substances hazardous to health.
Do not machine materials containing asbestos.
Asbestos is a known carcinogen.
Avoid contact with moving sanding or grinding tools.
Do not machine moist materials or damp surfaces.
NoTE! Do not allow the tool to come to a
standstill by overloading it!
Switch the device off and allow it to come to a
standstill before you put it down.
clean, dry and free of oil or grease.
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited must
never be allowed to use the device without super-
vision or instruction by a person responsible for
12 GB
Downloaded from www.Manualslib.com
Securely support the work-
RISK oF INJURY! Never
DUST HAZARD! Any
NoXIoUS FUMES!
RISK oF INJURY!
Always keep the device
manuals search engine
their safety. Children must never be allowed to
play with the device.

original accessories / tools

Use only the accessories and attachments de-
tailed in the operating instructions, or those which
are compatible with the tool.

Start-up

Attaching / changing the
tool / collet
Press and hold the spindle lock
Turn the clamping nut
Loosen the clamping nut
nation wrench for the thread.
33
If applicable, remove the attached tool.
First slide the tool you wish to use through the
clamping nut before inserting it into the
6
collet fitting the tool shaft.
7
Press and hold the spindle lock
Insert the collet into the threaded insert, then
7
tighten the clamping nut
tion wrench on the thread.
33
Using a tool with clamping mandrel:
Use the screwdriver end of the combination
wrench to loosen and tighten the screw on
33
the clamping mandrels.
Insert the clamping mandrel in the tool as de-
scribed.
Using the combination wrench
screw on the clamping mandrel.
Insert the attachment you wish to use onto the
screw between two washers.
Use the combination wrench
screw on the clamping mandrel.

Grinding bits

Firmly secure the brick
alent tool to prevent injuries.
.
8
until the lock catches.
6
using the combi-
6
.
8
using the combina-
6
, loosen the
33
to tighten the
33
! Use a vice or equiv-
23