Troubleshooting - Beem Cafe Joy V2 Bedienungsanleitung

Café Joy V2
The following table will help you locate and eliminate minor faults:
Fault
No symbol in the display.
The automatic circuit
breaker in the electrical
distribution board trips.
It is not possible to prop-
erly push the filter holder
into the brewing position.
The coffee runs very
slowly into the glass jug.
No water runs out of the
appliance despite pumping
noise.
The coffee runs onto the
hot plate.
Water runs out of the
appliance.
Water runs out of the
strainer holder.
44

Troubleshooting

Possible cause
Not plugged in.
No mains power.
Display is defective.
Too many appliances connect-
ed to the same power circuit.
No fault detected.
The permanent filter is not
properly seated in the filter
holder.
Drip-stop is blocked.
Appliance is scaled.
No water in the tank.
Glass jug is not properly
placed.
Too much water in the water
tank.
Drip tray is full.
No fault detected.
The edge of the strainer
holder is soiled by coffee
residues.
Remedy
Insert the mains plug.
Check the fuse/mains
socket.
Contact customer
service.
Reduce the number of
appliances on the power
circuit.
Contact customer
service.
Insert the permanent
filter properly, see
the section Inserting
the permanent filter
(page 33).
Clean the drip-stop.
Descale the appliance.
Fill with water.
Place the glass jug in
the middle under the
filter holder.
Do not overfill the water
tank.
Empty the drip tray.
Contact customer
service.
Clean holder and
strainer insert.
BEEM - Elements of Lifestyle
EN