Troubleshooting - AEG T6DBK82P Benutzerinformation

20 www.aeg.com

11. TROUBLESHOOTING

Problem
The tumble
dryer does not
operate.
Unsatisfactory
drying result.
The loading
door does not
close
It is not possible
to change the
programme or
option.
It is not possible
to select an opti‐
on. An acoustic
signal is emit‐
ted.
Possible cause
1)
The tumble dryer is not connected
to the mains supply.
The door is open.
The Aan/Uit button was not pus‐
hed.
The Start/Pauze button was not
touched.
The appliance is in standby mode.
Incorrect programme selection.
The filter is clogged.
Droogtegraad option was set to
Strijkdroog .
The load was too large.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into positi‐
on.
Laundry is trapped between the
door and the seal.
After a cycle starts it is not possi‐
ble to change the programme or
option.
The option you tried to select is not
available for the selected program‐
me.
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
Close the door.
Push the Aan/Uit button.
Touch the Start/Pauze button.
Push the Aan/Uit button.
Select a suitable programme.
Clean the filter.
Change Droogtegraad option to a
higher level.
4)
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Remedy
2)
3)
5)
3)