P74344ea_F1DW116-216C_QIG
Step 6: Connect the other end of the RJ45 cable to an OmniView ENTERPRISE
Step 7: Connect the VGA and PS/2 connectors to the computer (make sure that
Step 8: Set the video compensation switch to the appropriate position as
Note: If video resolution is poor, adjust the respective video compensation switch
± 1 position to improve.
Step 9: Repeat steps 5 through 8 for each additional computer you wish
Step 10: Connect the console keyboard, monitor, and mouse.* (For mouse and
Note: Dual-console support available on 2x8 and 2x16 models only.
Console 1
Downloaded from
www.Manualslib.com
17-10-2003
Quad-Bus Series Server Interface Module (Belkin part number
F1DE101A-AP).
you connect the keyboard and mouse cables to the correct ports on
your computer; purple indicates the keyboard connector and green
indicates the mouse connector).
described in the "Initial switch position for video compensation" chart.
to connect.
keyboard, use PS/2 or USB or any combination of both.
Console 2
Video console
(on F1DW216C)
ports VGA
Daisy-chain
port, In
PS/2 mouse
console port
PS/2 keyboard
console port
USB console
ports, Type A
manuals search engine
16:51
Page 5
CAT5 connectors
Daisy-chain
port, Out
Video compensation
switches
Power switch
IEC power connector