Steps For Putting Your Myopro 2 On - myomo MyoPro 2 Motion E Benutzerhandbuch

STEPS FOR PUTTING YOUR MYOPRO
1. POWER OFF: While donning, the MyoPro 2 should be turned OFF; check that it is OFF before starting to
put the MyoPro 2 on your arm.
NOTE: Pads and straps should be fully air-dried from the previous use.
▲
CAUTION: Do not use a hairdryer to dry components of the MyoPro 2.
2. PREPARE: Place the MyoPro 2 in your lap, or on a flat surface that is not slippery.
3. HAND: Start by feeding the fingers and hand through the Hand Support Shell. Be sure the strap around
the support shell sits at the base of your thumb. Tighten the Velcro strap around the hand.
NOTE: The motor and battery case should rest on the outside of the arm. If the motor and
battery case is aligned along the interior of the arm, you may be donning upside down or on
the wrong arm.
4. FOREARM: Lower your forearm into the Forearm Shell. Secure the Velcro of the Forearm Closure.
5. UPPER ARM:
•
Wrap the Upper Sensor Cuff around your upper arm, keeping attention on the Biceps and
Triceps sensors; when the Upper Sensor Cuff is properly fit, the sensors should be centered
over the biceps and triceps muscles.
NOTE: the sensor with the
triceps.
•
Secure the Upper Cuff Closure.
6. HARNESS: Secure the harness:
•
Rest the shoulder pad on the shoulder of your MyoPro 2 arm.
•
Wrap the strap under your non-MyoPro 2 arm.
•
Secure quick release tab.
PN26035 Rev5
Downloaded from www.Manualslib.com
BLUE
manuals search engine
2
ON
Velcro goes on biceps, the sensor with the RED Velcro goes on
10