Blade - MD Geräte MD300 Bedienungsanleitung

WARNING
Protect the battery contacts when the battery is not being used. Loose metal parts may
short-circuit the contacts – Explosion and fire hazard!
Start (see Illustration 11)
1. Press the start button (A) interlock.
2. Pull back the brake level (B) towards the handle.
3. The motor runs.
Stop (see Illustration 11)
1. Release the brake level (B) to turn off the mower
and the engine.
WARNING
After release the brake level, the blades will still rotate at up to 3 seconds.
Remove the battery
1. Press and hold the latch button under the battery and pull it out.
Working time
The working time per full charge depends of severalfactors, like length of grass, cutting
height and cutting methods (mulching, collection, side discharge).

9. Blade

Inspection of the blade
Remove the battery, make sure that the engine is turned off
•
Tilt the mower with the front upwards.
•
Inspect blade for damage, cracks or excessive rust or corrosion.
•
Check that the blade bolt is tightened.
NOTE: A dull blade can be sharpened! But a blade that is worn, bent, cracked or
otherwise damaged must be replaced.
Removing the blade (See illustration 12)
If you remove the blade to sharpen or replace it, you
must use a torque wrench and some heavy gloves to
protect your hands.
Loosen the blade bolt with the included tool. Use
1.
a piece of wood to prevent the blade from turning
around.
25
A
B
Illustration 11
Illustration 12