Technical Data - Scheppach HCP2600 Original Bedienungsanleitung

When storing fuel or equipment with fuel in tank
Store away from furnaces, stoves, water heaters,
clothes dryers or other appliances that have pilot light
or other ignition source because they can ignite fuel
vapors.
m Warning!
Spray contact with electrical wiring can result in elec-
trocution.
• Keep water spray away from electric wiring or fatal
electric shock may result.
m Warning!
Rapid retraction of starter cord (kickback) will pull
hand and arm toward engine faster than you can let
go. Broken bones, fractures, bruises or sprains could
result.
• ALWAYS point gun in safe direction and squeeze
spray gun trigger, to release pressure and avoid
kickback each time, before starting engine. Engage
trigger lock when not in use.
• When starting engine, pull cord slowly until resist-
ance is felt and then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to
run, always point gun in safe direction and squeeze
spray gun trigger to release high pressure.
• Firmly grasp spray gun with both hands when using
high pressure spray to avoid injury when gun kicks
back.
m Warning!
Running engines produce heat. Temperature of muf-
fler and nearby areas can reach or exceed 65°C.
Severe burns can occur on contact.
Exhaust heat/gases can ignite combustibles, struc-
tures or damage fuel tank causing a fire.
• DO NOT touch hot surfaces and avoid hot exhaust
gases.
• Allow equipment to cool before touching.
• Keep at least 1,5 m clearance on all sides of pres-
sure washer including overhead.
m Warning!
Starter and other rotating parts can entangle hands,
hair, clothing, or accessories.
• DO NOT wear loose clothing, jewelry or anything
that may be caught in the starter or other rotating
parts.
• Tie up long hair and remove jewelry.
m Caution!
High pressure spray may damage fragile items in-
cluding glass.
28 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• DO NOT point spray gun at glass when in jet spray
mode.
• NEVER aim spray gun at plants.
m Caution!
Improper treatment of pressure washer can damage
it and shorten its life.
• NEVER operate units with broken or missing parts,
or without protective housing or covers.
• DO NOT by–pass any safety device on this ma-
chine.
• NEVER move machine by pulling on hoses. Use
handle provided on unit.
Keep this safety information in a safe place.

6. Technical data

Motor
Engine power
Rotation speed max.
Fuel tank
Fuel
Engine Type
Starting System
Displacement
Oil type
spark plug
Water connection
Feed temperature max.
Feed volume min.
Min. feed pressure
Max. feed pressure
Max. Inlet hose length
Inlet hose diameter (inner
diameter)
Pump
Working pressure
Flow rate
Oil quantity ­ pump
Detergent suck
Max. recoil force of hand
spray gun
Detergent
Weight
3,2 kW
3600 min
­1
0,9 l
Gasoline (Unleaded)
4-stroke air cooled
Recoil starter
173 ccm
10W30
F7RTC
50 °C
9 l/min
0,2 MPa
1,0 MPa
15 m
min. Ø 12,7 mm
180 bar
8,7 l/min
0,1 l
450 ml/min
27 N
Only use cleaning
agents approved for
high pressure cleaners
26 kg