Cisco Linksys E-Serie Handbuch Seite 9

Linksys E-Series
network name (SSID) The Service Set Identifier (SSID) is the network name
shared by all devices in a wireless network It is case-sensitive and must not
exceed 32 keyboard characters The default is Cisco followed by the last 5 digits
of the router's serial number, which is found on the bottom of the router If
you used the setup software for installation, then the default Network Name is
changed to an easy-to-remember name
noTE
If you restore the router's factory default settings (by pressing
the Reset button or using the Administration > Factory Defaults
screen), the Network Name will return to its default value Change
the Network Name back to its original name, or you will have to
reconnect all devices on your wireless network to the new network
name
Channel Width
For best performance in a network using Wireless-B,
Wireless-G and Wireless-N (2 4 GHz) devices, select Auto (20 MHz or 40 MHz)
For a channel width of 20 MHz, keep the default, 20 MHz only
Channel Select the channel from the drop-down list for Wireless-B, Wireless-G,
and Wireless-N (2 4 GHz) networking If you are not sure which channel to
select, then keep the default, Auto
SSID Broadcast When wireless clients survey the local area for wireless
networks to associate with, they will detect the SSID broadcast by the router
To broadcast the router's SSID, keep the default, Enabled If you do not want to
broadcast the router's SSID, then select Disabled
Advanced Configuration
7