Inhaltsverzeichnis
Werbung
Kit VIDEO PRIVATE
Kit VIDEO PRIVATE
Activation of card reader
To activate the reader the MASTER card must be programmed. This is the
card that will serve, later, to access to the preogramming functions. The other
KIT functions will be operative even though the card reader is not activated.
The system will take as MASTER card the first one shown to it after the power
has been switched on.
+ -
1. Mark one of the cards as
MASTER. This card may not
be used as a personal card.
Reset of Master Card
If the MASTER card is lost or needs to be replaced, the following steps must
be taken (we recommend you entrust this task to specialised personnel).
1. Disconnect power supply.
2. Push door open button from the inside (if installed) or make a momentary
short circuit between terminals "B" and "-" of the reader controller. Reconnect
power supply.
3. The reader will go into "MASTER card change mode". All the reader's indicators
will start to blink for 5 seconds. The card shown to the reader during this time
will be taken as the new MASTERcard.
The card shown must not be already activated as a personal card.
If the card shown is the one ALREADY used as MASTER, the reader will lose
all the information stored (users cards, parameters,...). See page 34 for details.
NOTE:
The reader returns to normal mode, from any other programming setting, if no
card has been shown within a 30 second period.
+ -
2. Show the card to the
reader.
Beep!
Bee-Bee-Bee-Beep!
+ -
+ -
3. The reader is now
+ -
activated and ready for
operation after activation
of the necessary perso-
nal cards.
Pag 27
+ -
Werbung
Inhaltsverzeichnis
