Features; Installation - Eneo EDMC-142 Montageanleitung

1. Features

• Wall/Ceiling housing for Minitrax and WDDG- series
• Option: Multicore connection cable MCAB-, #87404

2. Installation

. Attach the mounting base (4) and plate (3) to the ceiling or wall using the
supplied M6 tapping screws (5) and plastic dowels ().
. Wind Teflon tape (3) around both threaded ends of the pipe (about 0 times) for
sealing. If necessary, use a silicone rubber sealant to seal the area where the
mount base and the pipe meet.
3. Fit the pipe (of which threads are covered by Teflon tape) into the mount base (4)
and turn until it is securely fastened.
4. Pull the required cable MCAB-, #87404 through the mount base (4) and pipe (6),
(7).
5. Align the housing (8) with the pipe and turn until it is securely fastened.
6. Fasten the mount base (4), housing (8) using the set screw ().
7. Install the vandal proof dome housing (8) using M6 torx screws (T-0) ().
84