Technical Specifications; Overload Indicator - Fagor BB-180 Gebrauchsanweisung

interior 30/6/05
1. INTRODUCTION
Your new scales are designed to provide a
highly accurate indication of the weight you
gain or lose during a certain period of time,
and they will last for many years under
normal conditions of use. We therefore
recommend you read this manual before
using the scales for the first time, and keep
it for later reference.
2. APPLIANCE DEFINITION (FIG. 1)
1. Weighing surface
2. Display
3. Battery compartment
Interference suppression: The
interference of this appliance has been
suppressed in accordance with interference
suppression standards.
Electromagnetic compatibility: This
appliance complies with the CEM standards
of electromagnetic compatibility.

3. TECHNICAL SPECIFICATIONS

• Capacity 150 Kg.
• Division 100 g
• Lithium batteries (CR 2032) (included)
• Foot pressure switch-on
• Automatic reset to zero
• Automatic switch-off
•

Overload indicator

• Battery low indicator
4. ADJUSTMENT
Remove the plastic insulation from the
battery contacts, on the underside of the
scales, before using them.
If the scales are to be out of use for some
time, either place the plastic insulation
between one of the contacts and the battery
or remove the batteries.
19:37 Página 4
EN
5. FUNCTIONING
Step 1. Place the scales on a hard, flat
surface (do not place them on a
carpet). To guarantee maximum
accuracy and repeatability of the
readings, always weigh yourself
with the scales in the same place.
Step 2. Switch on the scales by gently placing
your foot on the front right part. The
sequence is as follows:
The scales are now ready for you to
stand on them and weigh yourself.
Important: If you stand on the
scales before "0.0" appears on the
display, the error message will
appear:
Step 3. Stand carefully on the scales. Place
your feet firmly on the weighing
surface and stand still until the
scales calculate your weight. Your
correct weight will be shown as
follows:
This means: 68 kg and 300g
Step 4. When you step off the scales they
will automatically switch off. They
will also switch off if no-one stands
on them for around 8 seconds.
6. OVERLOAD INDICATOR
If the scales are overloaded (over 150 kg),
the error message "Err" will appear on the
display.
5