Operating Determinations - EuroLite Board 10ST Bedienungsanleitung

Always plug in the power plug least. The power-plug has to be accessable after installing the device.
Keep away from heaters and other heating sources!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless, disconnect
from mains immediately. Please let the device be checked by a qualified service technician before you
operate it again. Any damages caused by liquids having entered the device are not subject to warranty!
This device falls under protection-class I. Therefore it is essential that the yellow/green conductor gets
connected to earth. The electric connection must be carried out by a qualified employee.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
If the power-cord of this device will be damaged, it must be replaced by an authorized dealer or by a
qualified electrician in order to avoid any danger.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord.
Please note that damages caused by manual modifications on the device or unauthorized operation by
unqualified persons are not subject to warranty.
Keep away children and amateurs!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.

OPERATING DETERMINATIONS

This device is a switching panel for switching other devices like lighting effects or spots in discotheques, on
stages etc. This product is allowed to be operated with an alternating current of 115-230 V, 50-60 Hz and
was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
You can install the device at any desired place in dry rooms. Please make sure that the device is not
exposed to extreme heat, moisture or dust. There should not be any cables lying around. You endanger your
own and the safety of others!
Do not operate the device in extremely hot (more than 30° C) or extremely cold (less than 5° C) surroun-
dings. Keep away from direct insulation (particularly in cars) and heaters.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
8