Braun J 700 Handbuch Seite 10

3. Place the filter (6) onto the juice collector and
press it down until it locks on the motor coupling
(fig b).
4. Slide the pulp container (4) on to the rear part of
the motor unit until it connects. Be sure it snaps
into place (fig. c).
5. Attach the lid (7) (fig. c). Attach both clamps to
the lugs on the lid and push down firmly until you
hear them snap into place (fig. d).
6. Make sure the juice jug (13) is placed underneath
the juice spout (10) (fig. e). Capacity: 1250 ml.
The juice collector comes with a foam separator
(12) to help keeping the juice virtually foam-free. If it
is not required simply remove the foam separator.
Extracting juice
• Important: Use only well ripened fruits otherwise
the filter (6) may get clogged up.
• Before use, always unwind the power cord
completely from the cord storage (14).
• Fruits/vegetables need to be washed if they will
be processed unpeeled.
• Maximum operation time / amount at a time:
15 minutes / 5 kg.
Let appliance cool down sufficiently afterwards.
Type of fruits/ Preparation
vegetables
Hard fruits/ Remove inedible
vegetables e.g. peel
apples, pears, Process seed fruits
carrots, beets with cores
Leaf vegetables Roll up leaves
e.g. cabbage, together tightly
spinach or herbs before processing
Soft fruits/ Remove inedible
vegetables e.g. peel
citrus fruits, kiwis
Grapes Cut off main stems
Stone fruits e.g. Remove stones
plums, peaches
Melons Peel and cut into
pieces to fit the
filling shaft
Tomatoes, No further
cucumbers, preparation needed
raspberries
Berries Only suitable in
mixed juices
Rhubarb, fruits that contain starch
(bananas, mangoes, papayas,
avocados and figs), very hard and
fibrous fruits or vegetables
• Put fruits or vegetables into the filling shaft (8)
(fig. e).
• Turn the switch (2) to position «I» or «II»:
10
• Press slightly with the pusher (9) (fig. f). Add
more fruits or vegetables while the motor is
running.
• The amount of juice you extract depends on the
fruits and vegetables.
• Fruit and vegetable juices contain valuable
vitamins and minerals, which quickly deteriorate
when they come into contact with oxygen or light.
Drink juice fresh – right after it has been extracted.
Recipe Example:
Bitter lemon juice as ingredient for drinks & jam
Put 3 washed, untreated and unpeeled lemons into
filling shaft. Turn the switch to position «II» while
pressing constantly with the pusher to juice the
lemons for 5 seconds time. Let the device cool
down before repeating this recipe
Emptying the pulp container and filter
Pulp container (4): As soon as the pulp container
looks full turn off the appliance, unplug it and empty
the pulp container.
Filter (6): If the juice suddenly becomes much
thicker, if larger amounts of pulp get stuck between
filter and lid and/or if you can hear the motor speed
slow down, the filter and juice collector must be
emptied and cleaned (see «Disassembling »).
Empty the pulp container and assemble the appli-
Pro-
ance again.
cessing
Position II
Drip stop feature
When the juice spout (10a) is in a tilted position it
functions as a drip stop and collects the dripping
juice: Turn the appliance off, wait for a few seconds
until the drips slow down. Then push the spout (10a)
to the tilted position (fig. g).
Position I
Disassembling
1. Switch off the appliance by turning the switch (2)
to position « O » and unplug it (fig. h).
Model J700/J500: Put juice spout (10a) in upright
position to allow remaining juice to drain off.
2. Remove the pusher (9). Release the clamps to
unlock the lid (fig. h). Remove the lid.
3. Slide any of pulp from juice collector into the pulp
container.
4. Remove the juice collector (5) together with the
filter (6). Take the filter out of the juice collector
(fig. i).
5. Remove the pulp container (4) by pulling (fig. i).
6. Remove the juice spout (10a/10b) by pressing
on both sides with thumb and forefinger at the
Not
check marks (fig. j).
suitable
Cleaning
• Always remove the plug from the socket first!
• Disassemble the appliance as described in
«Disassembling».
(only model J700/J500)