Wäsche Nachlegen (Add Item); Fernstart (Remote Start) - LG F14WM12GT Bedienungsanleitung

Wäsche nachlegen (Add Item)
Laundry can be added or removed after the
washing programme is started.
1
Press the Wäsche nachlegen button when
the LED is turned on.
2
Open the door after door lock is released.
3
Add or remove laundry.
4
Press the Start/Pause button again to
continue the cycle. The cycle continues
automatically.
NOTE
• For safety reasons, the door remains locked
when the water level or temperature is high. It
is not possible to add laundry during this time.
• If the water temperature in the drum is high,
wait until it cools down.
CAUTION
• When adding laundry, make sure to completely
push it into the drum. If laundry gets stuck in
the door latch hole, the rubber packing may
be damaged, causing water leakage and
malfunction.
• Forcing the door open may cause part
damage, destruction, or safety problems.
• If you open the door while there are a lot of
suds and water in the drum, the suds or water
may flow, causing burn injury or wet floor.

Fernstart (Remote Start)

Use a smart phone to control your appliance
remotely. You can also monitor your cycle
operation so you know how much time is left in
the cycle.
NOTE
• You must first connect to a gateway and
register your appliance in order to use the
Remote Start function. (Refer to 'SMART
FUNCTIONS')
To Use Remote Start:
1
Press the Power button.
2
Put the laundry in drum.
3
Press and hold Fernstart button for 3
seconds to enable Remote Start function.
4
Start a cycle from the LG SmartThinQ
application on your smart phone.
NOTE
• If you do not start your appliance, it will wait to
start a cycle until you turn off your appliance
from the application or disable the Remote
Start function.
• When Remote Start is turned on, the door is
automatically locked.
To Disable Remote Start:
When the Remote Start is activated, press and
hold Fernstart button for 3 seconds.
NOTE
• If the door is open, Remote Start is disabled.
EN
29