THOMSON WEAR8500BT Bedienungsanleitung Seite 6

Warning – High volumes
• High sound pressure level!
• There is a risk of hearing damage.
• To prevent hearing loss, avoid listening at high volume levels for long periods.
• Always keep the volume at a reasonable level. Loud volumes, even over short
periods, can cause hearing loss.
• Using this product limits your perception of ambient noise. For this reason,
do not operate any vehicles or machines while using this product.
Warning – Battery
• Only use suitable charging devices or USB connections for charging.
• As a rule, do not charge devices or USB connections that are defective and do not try to
repair them yourself.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging or using the device in extreme temperatures and extremely low
atmospheric pressure (for example, at high altitudes).
• When stored over a long period of time, batteries should be charged regularly (at least
every three months).
4. Getting Started
• The earphones are equipped with rechargeable batteries. The batteries must be fully
charged before using the product for the rst time.
• Ensure that the earphones are switched off before charging them.
• Begin charging by connecting the included USB charging cable to the charging terminals (4),
and to the USB connection of a PC/laptop or a suitable power supply unit.
• The status LEDs (3) are constantly lit red during charging.
• It can take up to 1.5 hours to fully charge the battery.
Warning
Do not use the headset while it is charging.
• When the battery is fully charged, the status LEDs (3) are lit blue.
• Disconnect all cable and mains connections after use.
Note
If you have not used the device in several months, it may take 15 to 30 minutes of
charging before the status LEDs (3) light up red.
5. Operation
Switching the earphones on/off
• Turn On:
With the device off, press and hold both Multifunction buttons (2) at the same time for
3 seconds until a voice says, 'Power on'. The LED indicators (3) ash blue three times.
• Turn Off:
With the device on, press and hold one of the two Multifunction buttons (2) for
3 seconds until a voice says, 'Power off'. The LED indicators (3) brie y light up red.
The rst time the device is turned on, pairing is automatically started – see 5.1 Bluetooth
pairing.
®
3