Maintenance And Cleaning; Cleaning The Housing; Cleaning The Air Filter - SHE SHE18KL2001F Bedienungsanleitung

CLEANING THE HOUSING

Switch the device off prior to cleaning, wait a few minutes and then always the plug to
disconnect the device from mains.
Clean the device using a slightly damp cloth, follow up with a dry cloth.
•
For safety reasons never use water to clean the device. This could be dangerous.
•
Never use petrol, alcohol or solvents to clean the device.
•
Don't spray insecticides or similar agents onto the air conditioning unit.

CLEANING THE AIR FILTER

To assure the air conditioning unit's proper function you should clean the air filters every
week of operation.
The air filters are located in the air inlet guard.
1. Remove the exhaust hose.
2. Remove the air inlet cover from the back of the unit and
take the air filter out.
3. Use a vacuum cleaner to remove the dust accumulated in
the air filter.
4. If the air filter is very dirty, immerse it in warm water with a
little neutral detergent and rinse under running water (max
40 ° C).
5. Allow the air filter to dry well after washing, and then
reinstall it in the air intake grille.
EMTYING THE WATER TANK
The device has a water pump and an automatic water evaporation system. The vaporized air
is blown out through the exhaust hose.
If the water tank is still full or the water pump fails, the air conditioner will have a water level
safety switch. When the water level reaches a certain level, the water level indicator lights up
(warning light W.F on the control panel) and you must drain the water tank.
To empty the condensed water tank, proceed as follows:
1. Pull the plug out of the outlet.
2. Place a catchment container underneath the condensation
outlet on the back of the device, carefully remove the
sealing cap and plug from the outlet and drain the water
into the catchment container. Towards the end, slightly tilt
the air conditioning unit (no more than 30°) grabbing it at
the handle with one hand and at the upper edge of the air
outlet with the other.
3. Once the tank is fully emptied carefully place the plug back in the water outlet and
screw the sealing cap back on.
4. Plug the device back in and start it up.

MAINTENANCE AND CLEANING

NOTE: Never use the device without the filters.
Seite 30 von 40
Air inlet
cover
Condensation
water outlet