Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Sharp R-360 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für R-360:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4

TROUBLESHOOTING

If you think the oven is not working properly there are some simple checks you can carry
out yourself before calling an engineer. This will help prevent unnecessary service calls if the
fault is something simple.
Follow this simple check below:
Place half a cup of water on the turntable and close the door.
Programme the oven to cook for 1 minute using 100% microwave power.
1. Does the oven lamp come on when it is cooking?
2. Does the microwave stirrer rotate?
3. Does the cooling fan work? (Check by placing your hand above the air vent openings.)
4. After 1 minute does the audible signal sound?
5. Is the water in the cup hot?
If you answer "NO" to any question first check that the oven is plugged in properly and
the fuse has not blown. If there is no fault with either, check against the troubleshooting
chart below.
WARNING: Never adjust, repair or modify the oven yourself. It is hazardous for
anyone other than SHARP trained engineer to carry out servicing or repairs. This is
important as it may involve the removal of covers that provide protection against
microwave energy.
• The door seal stops microwave leakage during oven operation, but does not form an air-
tight seal. It is normal to see drops of water, light or feel warm air around the oven door.
Food with a high moisture content will release steam and cause condensation inside the
door which may drip from the oven.
• Repairs and Modifications: Do not attempt to operate the oven if it is not working prop-
erly.
• Outer Cabinet & Lamp Access: Never remove the outer cabinet. This is very dangerous
due to high voltage parts inside which must never be touched, as this could be fatal.
Your oven is not fitted with a lamp access cover. If the lamp fails, do not attempt to re-
place the lamp yourself, call a SHARP approved service facility.
• Cool down function: If the Microwave is set for 2 mins or longer (in any mode) once the
program ends it will enter into a 3 min cool down where the fan only will remain on. This
is not a fault and it is not still cooking, the fan will stop after 3 minutes.
User_manual_R360_WEST.indb 25
GB-25
2016-08-10 16:19:32

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

R-360s

Inhaltsverzeichnis