Kenwood KDC-X7100DAB Bedienungsanleitung Seite 17

BLUETOOTH®
Pair and connect a Bluetooth device for the first time
1 Press to turn on the unit.
2 Search and select this unit model name (KDC-X7***DAB) on the Bluetooth
device.
"PAIRING" "PASS XXXXXX" Device name "PRESS" "VOLUME KNOB"
appears on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3 Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
Once pairing is completed, Bluetooth connection is established automatically.
• "BT1" and/or "BT2" indicator on the faceplate lights up.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device,
[DEVICE DELETE].
• A maximum of two Bluetooth phones and one Bluetooth audio device can be
connected at any time.
However, while in BT AUDIO source, you can connect to five Bluetooth audio
devices and switch between these five devices. ( 17)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more information.
Auto Pairing
When you connect iPhone/iPod touch/Android device to the USB input terminal,
pairing request (via Bluetooth) is automatically activated.
Press the volume knob to pair once you have confirmed the device name.
Automatic pairing request is activated only if:
– Bluetooth function of the connected device is turned on.
– [AUTO PAIRING] is set to [ON]. ( 17)
– KENWOOD MUSIC PLAY application is installed on the Android device ( 10)
and [BROWSE MODE] is selected. ( 11)
Connect with a remote device by One-touch (NFC)
Near Field Communication (NFC) enables short-range wireless
communication between the unit and remote devices such as
smartphones.
By holding an NFC-compatible remote device near to the N-Mark
on the unit (right side of the panel), the unit and remote device
proceed to complete pairing and established the BLUETOOTH
connection automatically.
1
Activate the NFC function on the remote device.
Refer to the instruction manual of the remote device for more
information.
2
Hold the remote device near to the N-Mark on the unit
(right side of the panel).
The device vibrates when pairing is completed.
16,
• Depending on the type of remote device used, the strength of
the NFC signal may vary. For a stronger NFC signal, user must
understand the position of the remote device's NFC antenna
and hence tap the NFC antenna with the NFC logo.
• To disconnect, hold the remote device near to the N-Mark on
the unit again.
• This unit only can recognize and connect to one NFC-
compatible device at a time.
13
ENGLISH