Installation - Juniper WX 15 Kurzanleitung

Installation:

WX 15, WX 20, and WXC 250 QUICK START
Set up the chassis.
• For rack mount installation, install the supplied brackets, front panel
forward, to the sides of the device.
• For desktop installation, install the rubber stands in the recessed
areas on the bottom of the chassis (pre-installed on the WX 15).
NOTE: Do not connect the power cable until Step 4.
Connect the network cables.
To connect the network cables:
• Locate the cable that connects from the switch (or other aggregating
device) to the router.
• Disconnect this cable from the router port and connect it to the
LOCAL port on the WX device.
• Connect a straight-through cable (not provided) from the router port
to the REMOTE port on the WX device.
–
Verify connectivity across the WX device.
One method of testing connectivity between devices is to Ping a host on
the remote side of the device from a host on the local side of the device.
NOTE: If you are not able to verify connectivity on both sides of the device,
— do not proceed to the next step. Ensure that you are using the correct cables
(crossover vs. straight-through), and verify that there is network connectivity
before applying power.
˜
WX 15
Router (remote device)
Switch (local device)
SR-15
POWER STATUS OP BYPASS DISABLE
Model No. SR-15 PERIBIT NETWORKS
||||||||||||||||||||||||||||||||||||||||||||||||||
S/N 0123456789
CONSOLE
100/240V 50-60 ~ 1/.5A
100/10
LINK
LOCAL
100/10 LINK
LINK 100/10
BYPASS
DISABLE
LOCAL REMOTE
LINK
100/10
REMOTE