Administration > Factory Defaults; Factory Defaults; Administration > Upgrade Firmware; Upgrade Firmware - Cisco Linksys WET610N Benutzerhandbuch

Linksys WES610N/WET610N
Restore Click Browse and select the configuration file Then click Restore
Configurations
System Reboot
Reboot To reboot or restart the bridge, click Start to Reboot
Click Save Settings to apply your changes, or click Cancel Changes to cancel
your changes
Administration > Factory Defaults
Use this screen to restore the bridge's configuration to its factory default
settings

Factory Defaults

Restore All Settings To reset the bridge's settings to the factory defaults, click
Restore All Settings Any settings you have saved will be lost when the default
settings are restored
Administration > Upgrade Firmware
Use this screen to upgrade the bridge's firmware Do not upgrade the firmware
unless you are experiencing problems with the bridge or the new firmware has
a feature you want to use
Before upgrading the firmware, download the bridge's firmware upgrade file
from the Linksys website, www.Linksys.com/support

Upgrade Firmware

Please select a file to upgrade the firmware
firmware upgrade file Then click Start to Upgrade and follow the on-screen
instructions
Status > Bridge
The bridge's current status information is displayed
Advanced Configuration
Click Browse and select the
15