Operation - Airthereal MA10K-PRODIGI Handbuch

OPERATION

1. Insert the power cord into an electrical outlet.
2. Place the unit at least 15 inches away from TVs, radios, and other electronic
products. Make sure there's plenty of space to Ozone throw off.
DISCLAIMER:
Please make sure the operating voltage is the same as shown on the parametric label.
This unit will not function properly using in conjunction with external devices that alter
or convert voltage or frequency of electricity.
3. Getting Started
• Insert the power cord into an electrical outlet.
• Before beginning ozone treatment, thoroughly clean up the source of the odor first.
And then close doors and windows, making sure the room is sealed completely.
Please note that all ozone machines have to be used in unoccupied space only.
• Press Power Button to turn the power on. When turned on, the LCD will light up,
and the Fan Speed and Ozone Control are twinkling. The unit comes with a 5-second
delay. The 5-second delay is activated without any button operation. Once any
button is being pressed, the 5-second delay will stop counting down. When the
5-seconds delay countdown ends, the unit will start operation, which gives users
enough time to leave without breathing in ozone directly.
After 5 seconds, the unit will produce ozone according to the default settings. By
default, the unit will run with the lowest ozone output (2g/h) and the minimum fan
speed (40 CFM).
NOTE: The ozone generator will produce ozone after 5 seconds when you finish
the setting on the LCD.
6