Belkin F5U508 Benutzerhandbuch Seite 16

P73954ec-A-F5U508-man.qxd 22-11-2002 15:41 Page 12
4. Once the computer has completely shut down, remove the
5. Remove the port cover that corresponds with the PCI slot
6. Insert the PCI Card into the slot. Apply pressure as needed
7. After installing the PCI Card, replace the outer cover and
8. When Windows restarts the PCI card will be detected and
Note: Depending on the speed of your computer, it may take
up to 30 seconds for the PCI card to be detected.
9. Windows will detect the "PCI Standard PCI to PCI Bridge"
10. Windows will locate the drivers for "PCI Standard PCI to PCI
11. Installation of the "PCI Standard PCI to PCI Bridge" will now
12. Windows will detect the "NEC Firewarden OHCI Compliant
Downloaded from www.Manualslib.com
Installation (continued)
computer's cover and locate an empty PCI slot.
you wish to use. (The cover is usually held in place with a
single screw.)
until the card is fully seated. Secure the PCI card with the
screw removed in step #5, above.
turn on the computer.
installation of the required drivers will begin.
and the "Add New Hardware Wizard" dialog box will open.
Select "Automatic Search for the best driver for your device
(Recommended)" and click "Next".
Bridge". (Windows may prompt you to insert the Windows
OS installation CD. If so, insert the CD into the CD-ROM
drive and continue the installation procedure).
complete. Click "Finish".
IEEE 1394 Host Controller". Click "Next".
manuals search engine
12