SEVERIN CS 7976 Gebrauchsanweisung Seite 8

Safety switch
The appliance is equipped with a safety
switch. Any attempt to remove the shaving
head will cause the appliance to switch off
automatically in order to prevent personal
injury or damage to the appliance.
Batteries
This appliance requires two batteries of type
LR14 / 1.5 V (size C); the use of alkaline
batteries is preferable, as they are longer-
lasting than the standard carbon-zinc
batteries. The batteries are inserted as
follows:
- Slide the battery compartment cover in
the direction indicated by the arrow and
take it off.
- Insert the batteries according to the
schematic
compartment, ensuring correct polarity
(+/-).
- Replace the compartment cover and
slide it back until it is heard locking into
place.
●
When the lint chamber is empty, a
significant decrease in operating speed is
a clear indication that the batteries are
exhausted, and that they should be
replaced.
Operation
- Place the item to be treated on a level
surface.
- Remove the protective cover from the
head. For coarser wool surfaces, the use
of the spacer ring is recommended.
- Use the On-/Off switch to turn the
appliance on. The shaving blades inside
the shaving head start rotating. When
they come into contact with the surface
of the area to be treated, a distinct noise
can be heard. This is normal.
- Guide the shaving head gently and
without exerting any pressure over the
fabric to be treated. Lint and fuzz balls
are removed and collected in the lint
chamber.
●
The chamber should always be emptied
Downloaded from www.Manualslib.com
diagram inside
manuals search engine
in good time. If the motor seems to lose
power, or if it stops working completely,
the lint chamber may be over-full.
- Turn the appliance off after use.
General care and cleaning
●
Before cleaning the appliance, turn the
motor off and remove the batteries from
the battery compartment.
●
To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
●
Do not use abrasives or harsh cleaning
solutions.
- To empty the lint chamber, slide it out of
the appliance in the direction indicated
by the arrow. Once emptied, slide the
chamber back into the appliance until it
the is heard locking into place.
- The exterior housing may be wiped with
a slightly damp soft cloth.
- The shaving head can be cleaned as
follows:
- Remove the spacer ring and the
protective cover from the appliance.
- Take off the shaving head by
unscrewing it in an anti-clockwise
direction.
- Caution: Exercise extreme caution
when removing the lint residues. The
blades are very sharp, and there is a risk
of injury.
- Replace the head back on the
appliance and turn it clockwise to
secure. Replace the protective cover
and – if applicable – the spacer ring.
Disposal
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
Guarantee
This product is guaranteed against defects in
materials and workmanship for a period of
two years from the date of purchase. Under
this guarantee the manufacturer undertakes
8