Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Possible Cause - Manupro MPSOR305DBS Betriebsanleitung

Zug-, kapp- und gehrungssäge
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste elec-
trical and electronic equipment.
Improper handling of waste equipment may have
negative consequences for the environment and hu-
man health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natu-
ral resources. You can obtain information on collec-
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.

14. Troubleshooting

Fault

Possible cause

Motor does not work
Motor, cable or plug defective, fuses
burnt
The motor starts up
Voltage too low, coils damaged,
slowly and does not
capacitor burnt
reach operating speed.
Motor makes excessive
Coils damaged, motor defective
noise
The motor does not
Circuits in the network are overload-
reach its full power.
ed (lamps, other motors, etc.)
Motor overheats easily.
Overloading of the motor, insufficient
cooling of the motor
Saw cut is rough or
Saw blade dull, tooth shape not ap-
wavy
propriate for the material thickness
Workpiece pulls away
Excessive cutting pressure and/or
and/or splinters
saw blade not suitable for use
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage. Ar-
range for inspection of the motor by a specialist. Ar-
range for replacement of the capacitor by a specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the
same circuit
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal cool-
ing of the motor
Re-sharpen saw blade and/or use suitable saw blade
Insert suitable saw blade
GB
31

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis