Care And Maintenance; Specifications - TFA IQ-WS 35.1040 Betriebsanleitung

POSITIONING THE THERMO-HYGRO TRANSMITTER:
Table stand/wall
mount bracket
Note:
Before permanently fixing the transmitter wall base, pace all units in the desired locations to
check that the outdoor temperature and humidity readings are receivable. In event that the
signal is not received, relocate the transmitters or move them slightly as this may help the signal
reception.

CARE AND MAINTENANCE:

•
Extreme temperatures, vibration and shock should be avoided as these may cause
damage to the units and give inaccurate forecasts and readings.
•
When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or
scouring agents as they may mark the LCD and casings.
•
Do not submerge the units in water.
•
Immediately remove all low powered batteries to avoid leakage and damage. Replace only
with new batteries of the recommended type.
•
Do make any repair attempts to the units. Return it to their original point of purchase for
repair by a qualified engineer. Opening and tampering with the units may invalidate their
guarantee.
•
Do not expose the units to extreme and sudden temperature changes, this may lead to
rapid changes in forecasts and readings and thereby reduce their accuracy.

SPECIFICATIONS:

Temperature measuring range:
Indoor : -10ºC to +69.9ºC with 0.1ºC resolution
+14°F to +157.8°F with 0.2°F resolution
("OF.L" displayed if outside this range)
Outdoor : -29.9ºC to +69.9ºC with 0.1ºC resolution
-21.8°F to +157.8°F with 0.2°F resolution
("OF.L" displayed if outside this range)
Relative humidity measuring range:
Indoor : 1% to 99% with 1% resolution
("- -" displayed if outside this range)
Outdoor : 1% to 99% with 1% resolution
("- -" displayed if outside this range)
Indoor temperature checking interval : every 15 seconds
Indoor humidity checking interval
Outdoor temperature reception
Outdoor humidity reception
Transmitter checking interval
Air pressure checking interval
Transmission range
Power supply:
Weather Station
Thermo-hygro transmitter
Battery life cycle
(Alkaline batteries recommended)
The Thermo-hygro transmitter can be placed onto
any flat surface or wall mount using the bracket
which doubles as a stand or wall mount base.
To wall mount:
1. Secure the bracket onto a desired wall using
the screws and plastic anchors.
2. Clip the transmitter onto the bracket.
: every 20 seconds
: every 5 minutes
: every 5 minutes
: every 1 minute
: every 15 seconds
: up to 100 meters (open space)
: 3 x AA, IEC LR6, 1.5V
: 2 x AA, IEC LR6, 1.5V
: approximately 12 months
45