Bartscher 601182 Handbuch Seite 11

ASSEMBLY
Assembly of the posts
1) All four posts consist of two parts and are screwed together with the help of the
connecting pieces with threads that should already have been screwed to one of the
two post parts. The upper part of the posts has a plastic cover at the top, the lower
part of the post can be levelled at the bottom. Screw together the two parts of the
post hand-screwed in a clockwise direction. Should it not be possible to screw the
two post parts together easily, then the two thread parts were not joined properly.
Attaching a shelf
2) Attach the bottom shelf to the corner posts first. It is
recommended that the bottom shelf should not be
mounted higher than 15 cm above the floor.
At the desired height, snap the conical plastic snap-fit
joints into the grooves on the posts, with the narrower
end of the snap-fit joints pointing up and the thicker
end of the snap-fit joints pointing down.
3) Tilt the shelf slightly to the side and slide the upper
parts of the four posts (with plastic caps) through
the openings in the shelf's corners until they are
firmly seated at snap-fit joints.
4) Place the entire rack upright and push the shelf
down firmly at the corners, to make sure that the
shelf lies firmly on the plastic snap-fit joints.
- 7 -