Installation - Blaupunkt TrackCam VIO-HP20 Schnellstartanleitung

5. Installation

•
Check your WiFi signal strength and make sure that the WiFi signal is strong at
the location of your camera. For best performance, the smartphone needs to be
connected to a WiFi network.
5.1. Micro SD installation (optional)
Pull the camera lens up and locate the Micro SD-Card compartment (refer to
Step 1:
chapter 2 point
Step 2:
Install the Micro SD-Card into the indicated MicroSD-card slot.
NOTE: The Micro SD-Card is mandatory for local recording. Please make sure
the Micro SD-Card is CLASS10 rated. Supported are Micro SD-Cards from 8GB
to 256GB.
5.2. Installation
Step 1:
Stick the mounting map
sticker on the wall or ceiling, then use it
as a template to mark the three drilling
points.
Step 2:
Drill through the marked
points and install the plastic anchors on
the three holes.
10
4
)
Step 3:
on the ceiling and drive the screws into
the plastic anchors until they are flush
with the mounting bracket and the
bracket is flat against the wall.
Step 4:
mounting bracket and turn it clockwise
to lock it.
1
Mounting Surface
2
Positioning Map
3
Plastic Anchors
4
Mounting Plate
5
Screw
6
Camera
Place the mounting bracket
Install the camera on the