Samsung DVD-P560 Handbuch Seite 11

Connection to a TV (Interlace)
- Connecting to your TV using Component video cables.
- You will enjoy high quality and accurate color reproduction images. Component video sepa-
rates the picture element into black and white(Y), blue(P
and clean images. (Audio signals are delivered through the audio output.)
1
Using component video cables (not included), connect the
COMPONENT VIDEO OUT terminal on the rear of the
DVD player to the COMPONENT IN terminal of TV.
2
Using the audio cables, connect the AUDIO (red and
white) OUT terminals on the rear of the DVD player to the
AUDIO (red and white) IN terminals of TV. Turn on the
DVD player and TV.
3
Press the input selector on your TV remote control until the
Component signal from the DVD player appears on the TV
screen.
4
Set the Video Output to Component (I-SCAN) in the
Display Setup menu. (See pages 27 to 28)
Note
- If Video output is incorrectly set to S-VIDEO with the Component cables connected, the screen will
turn red.
- If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 13 to 14)
- The component terminal of TV can be marked by "R-Y, B-Y, Y" or "Cr, Cb, Y" instead of "P
depending on the manufacturer. The number and position of terminals can vary depending on the TV set.
Please refer to the user's manual of the TV.
Downloaded from www.Manualslib.com manuals search engine
), red(P ) signals to present clear
B R
RED BLUE GREEN
RED WHITE
Audio Cable
WHITE
RED
Component cable
RED BLUE GREEN
(not included)
, P , Y"
R B
11