Troubleshooting; Specifications - Lightning Audio La Storm X1.1000.1D Einbau Und Betrieb

Troubleshooting

Symptom
Amplifier does not
turn on.
Amplifier Noise
(Turn-On Pop)
Engine Noise

Specifications

MODEL- Storm
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4Ω Load Per Channel
2Ω Load Per Channel
4Ω Load Bridged (Mono)
X1.1000.1D & X1.2000.1D Only
1Ω Load Bridged
Dimensions: -
add 1.5" (xcm) to length for mounting feet
Signal-to-Noise Ratio
Input Sensitivity
Crossover (X1.1000.1D & X1.2000.1D only)
Crossover (X1.400.2 & X1.800.4 only)
Crossover Frequency
Channel Separation
Bass Equalization (X1.1000.1D & X1.2000.1D only)
Specifications subject to change without notice
12
Downloaded from www.Manualslib.com
Diagnosis
B+ or REM not between 10.5 and
15.5 volts or no voltage present
Amplifier is not properly grounded.
Voltage spike from source unit is
entering amplifier's input
Noise is radiating into signal cables
X1.1000.1D
400 Watts x 1
700 Watts x 1
1000 Watts x 1
Height 2.2" (5.6cm)
Width 10.4" (26.42cm)
Length 14" (35.56cm)
manuals search engine
Remedy
Check the alternator, battery, fuse,
and wiring and repair as necessary
Check wiring and repair as necessary
Connect a relay turn-on module to
REM terminal if pops are eliminated
with no input signal to amplifier
Re-route signal cables away from
sources of high current
X1.2000.1D X1.400.2
700 Watts x 1 100 Watts x 2
1200 Watts x 1 200 Watts x 2
400 Watts x 1
2000 Watts x 1
2.2" (5.6cm) 2.2" (5.6cm)
10.4" (26.42cm) 10.4" (26.42cm)
22.0" (56.00cm) 15.2" (30.61cm)
>90dB A-weighted
150mV - 4V
24dB/octave Low Pass only
24dB/octave HPF/Flat/LPF Switch
variable from 50Hz to 250Hz
50dB
Variable from 0dB to +12dB @ 20-80Hz
X1.800.4
100 Watts x 4
200 Watts x 4
400 Watts x 2
2.2" (5.6cm)
10.4" (26.42cm)
18.6" (47.24cm)