Inhaltsverzeichnis
Werbung
®
R&S
NGE100
Risk of electric shock
It is prohibited to disconnect the earthed protective connection inside or out-
side the instrument!
If it is assumed that a safe operation is no longer possible, the instrument must be
shut down and secured against any unintended operation.
Safe operation can no longer be assumed as follows:
● Instrument shows visible damage
● Instrument includes loose parts
● Instrument no longer functions properly
– After an extended period of storage under unfavorable conditions (e.g. out-
doors or in damp rooms)
– After rough handling during transport (e.g. packaging that does not meet
the minimum requirements by post office, railway or forwarding agency)
Exceeding the Low Voltage Protection
Use insulated wires and not bare wires for the terminal connection.
For the series connection of all output voltages, it is possible to exceed the
low voltage protection of 42 V. Please note that in this case any contact
with live components is life-threatening. It is assumed that only qualified
and trained personnel service the power supplies and the connected loads.
Prior to switching on the product, it must be ensured that the nominal voltage set-
ting on the product matches the nominal voltage of the AC supply network. If it is
necessary to set a different voltage, the power fuse of the product may have to be
changed accordingly.
3.2
Intended Operation
The instrument is intended only for use by personnel familiar with the potential
risks of measuring electrical quantities.
Getting Started 5601.1308.02 ─ 04
Putting into Operation
Intended Operation
10
Werbung
Inhaltsverzeichnis
