Cleaning The Rollers; Cleaning Material - Fujitsu fi-412PR Bedienungshandbuch

4.3. Cleaning the Rollers

When ink or dust from paper is stuck on the imprinter feed
roller surfaces, documents may not feed smoothly. To
prevent feed problems, clean the rollers' surfaces regularly.
HINT
1. Open the imprinter cover.
2. Clean the roller surfaces with a lint-free cloth
moistened with Cleaner F1 by wiping off all dirt
and dust.
Clean the lower rubber rollers (total of six) by holding
down both the [Scan] and [Send to] buttons on the
front panel of the scanner and rotating the rollers.
ATTENTION
3. Cleaning the Plastic Rollers.
Also, clean the two black plastic rollers on the inner
side of the Imprinter cover.
Rotate the rollers with your fingers gently and wipe
off any dirt or dust from the roller surface with a
lint-free cloth moistened with Cleaner F1.
4. Confirm that all dirt and dust have been removed
from the rollers. Close the Imprinter Cover.
Downloaded from www.Manualslib.com
Recommended cleaning cycle is every 1,000 sheets.
Actual cleaning cycle may be shorter depending on
usage and documents.
Imprinter Cover
When cleaning, be careful not to touch the
metal wheels located behind the upper rollers
on the print cartridge holder cover.
Imprinter Cover
manuals search engine

4.4. Cleaning Material

Cleaning Materials Parts No.
Cleaner F1
CA99501-0013
* To purchase the cleaning material, contact the FUJITSU scanner
dealer where you purchased the scanner.
fi-412PR Imprinter Operator's Guide | 15
Remarks
1 bottle (100ml)