Leica ER 6.5-26x56 LRS Anleitung Seite 22

EN
7. Fire a test shot again after correction.
When the position of reticle and point of
impact are aligned, weapon and telescopic
sight are zeroed.
8. Zeroing the turret scales
a) Elevation: Loosen the two Allen screws,
lift the turret slightly and then turn it so
that the scale mark on the turret is aligned
with the index mark (6c) on the tube body
in position "0". Press it down in this
position and fix it using the two Allen
screws.
18
b) Windage: Loosen the cross-head screw
on the upper side of the turret and turn the
lower scale ring (5c) so that the scale mark
of the knurled ring is aligned with the index
mark on the tube body in position "0". Then
fix it in this position by tightening the two
cross-head screws again.
Your telescopic sight is now ready for use.